Power:

• AC power: 100-240 V AC nominal, 50/60 Hz
• Power supply unit: Auto-ranging electronic switch mode
• Typical half-cycle RMS inrush current at 230 V, 50 Hz: 3,0 A
• Typical earth-leakage current: 0,80 mA
• Power Factor: 0,99 @ 100 V / 120 V , 0.97 @ 208 V, 0,96 @ 230 V, 0,95 @ 240 V
• Max current draw: 4,0 A @ 100 V / 120 V , 1,9 A @ 208 V / 230 V / 240 V
• Typical current draw: 3,6 A @ 100 V , 3,0 A @ 120 V , 1,7 A @ 208 V , 1,6 A @ 230 V , 1,6 A @ 240 V
• Maximum: 400 W
• Typical: 358 W
• Idle: 14 W

Optical and photometric:

• Lens Diameter: 200 mm
• Front Accessory Holder: PAR64 size
• Beam/Strobe LED:
  • LED Type: RGBW
  • total lumen output: 13.000 lumens (boost/strobe mode)
  • total lumen output: 8.000 lumens (continuous mode)
  • Center intensity: 170.000 cd (boost/strobe mode)
  • Center intensity: 103.000 cd (continuous mode)
  • Beam Angle: 12 Degrees (half peak)
  • Field Angle: 26 Degrees (one-tenth peak)
  • Binning: Tight color and flux binning
  • Calibration: Full Gamut Color Calibration
  • Color Modes: Extended Mode and Calibrated Mode
  • CRI (Color Rendering Index): >83 (at 6.500 K mixed white)
  • CQS (Color Quality Scale): >87 (at 6.500 K mixed white)
  • TM-30 Rf (IES TM-30-15 Fidelity Index): >83 (at 6.500 K mixed white)
  • TM-30 Rg (IES TM-30-15 Gamut Index): >106 (at 6.500 K mixed white)
  • TLCI (Television Lighting Consistency Index): >85 (at 6.500 K mixed white)
  • Color Temperature: variable (2.000 – 11.000 K)
  • Resolution: 16-bit per color
  • Minimum LED lifetime: 50.000 hours (to >70% luminous output)
• Aura Backlight LEDs:
  • LED Type: RGB
  • LED Quantity: 72
  • Binning: Tight color and flux binning
  • Calibration: Full Gamut Color Calibration
  • Color Modes: Extended Mode and Calibrated Mode
  • Color Temperature: Variable (2.000 – 11.000 K)
  • Resolution: 16-bit per color per pixel
  • Minimum LED lifetime: 50.000 hours (to >70% luminous output)

P3 video processing:

• Color Resolution: 16 bit per color (48 bit per pixel) (Beam & Aura)
• Color Temperature Control: 2.000 – 11.000 K (Beam & Aura)
• Synchronization: system-wide
• Frame Rate: up to 75 frames/sec
• Brightness Control: 0-100% (maintaining full color depth)
• Color Gamut Control: full spectrum control (Beam & Aura)
• Gamma Correction and Control: fully controllable (Beam & Aura)

Effects:

• Beam Dimmer/Shutter: 0 – 100% continuous dimming, variable flash rate and duration, and atomic effects
• Beam Dimming options: Choice of four dimming curves
• Beam Color mixing: RGB, independently variable 0 - 100%
• Beam Color temperature control: Variable 2.000 – 11.000 K
• Beam Virtual Color wheel: 48 color presets, continuous rotation and random color
• Beam P3 Mix: Videomapping of fixture with variable crossfade between DMX control and video control
• Aura Dimmer/Shutter: 0 – 100% continuous dimming, regular and random strobe effects
• Aura Dimming options: Choice of four dimming curves
• Aura Color mixing: RGB, independently variable 0 - 100%
• Aura Color temperature control: Variable 2.000 – 11.000 K
• Aura Virtual Color wheel: 48 color presets, continuous rotation & random color
• Aura PixelMapping: individual RGB control of each Aura pixel
• Aura P3 Mix: Videomapping of fixture with variable crossfade between DMX control and video control
• Built-in FX: Various pre-programmed FX on Beam, Aura and combination of both

Heat management:

• Cooling: Forced air (temperature regulated, low noise)
• Maximum ambient temperature (Ta max.): 40 C
• Minimum ambient temperature (Ta min.): 0 C
• Typical heat dissipation (calculated, +/- 10%): 1.365 BTU/hr

Control and programming:

• DMX channels: 1, 3, 4, 10, 27, 243
• DMX compliance: USITT DMX512-A
• RDM compliance: ANSI/ESTA E1.20
• DMX/RDM Transceiver: RS-485
• Control Protocols: DMX, RDM, Art-Net, RDM over Art-Net, sACN and P3
• Protocol detection: Automatic
• Setting and addressing: RDM, RDM over Art-Net or P3
• DMX Modes: 1-channel, 3-channel, 4-channel, Compact, Basic, Extended
• Fixture Identification: User-settable ID number
• Art-Net Compliance: Art-Net 1, 2, 3 and 4; including RDM over Art-Net
• sACN Compliance: ANSI E1.31 – 2016
• Martin P3 Compliance: P3 System Controller Software 5.1.0 or newer
• Ethernet Transceiver: 10/100 Mbit (with fail-safe bypass)
• Firmware update: via DMX using Martin Companion or via Ethernet using P3 System Controller
• Device status: Multi-color status LED
• Device test and reset: Pushbutton to call up local test patterns and reset device

Connectors:

• AC Power, DMX and Network input: cable tail with PDE hybrid connector (IP65)
• AC Power, DMX and Network thru: chassis-mount PDE hybrid connector (IP65)
• All connections hot plugging compatible

Installation:

• Mounting options: hanging from bracket, hanging from clamp attached directly to fixture, hanging from other fixture using interlock mechanism or floor standing using integrated double bracket
• Location: indoor or temporary outdoor use
• Clamp attachment to hanging bracket: M12
• Clamp attachment directly to fixture: M8
• Maximum vertical column height: 4 fixtures
• Orientation: Any
• Minimum distance to combustible materials: 0,1 m
• Minimum distance to illuminated surfaces: 0,5 m

Housing:

• Housing: Aluminum
• Color: Black
• Protection rating: IP65

Physical:

• Width excluding hanging bracket: 288 mm (11,3 in.) (identical to 2x VDO Atomic Dot locked together)
• Width including hanging bracket: 371 mm (14,6 in.)
• Height excluding hanging bracket: 288 mm (11,3 in.) (identical to 2x VDO Atomic Dot locked together)
• Height including hanging bracket: 394 mm (15,5 in.)
• Horizontal fixture spacing: 300 mm (11,8 in.) (center-to-center using interlock couplers)
• Vertical fixture spacing: 300 mm (11,8 in.) (center-to-center using interlock couplers)
• Depth: 161 mm (6,3 in.)
• Weight including hanging bracket: 9,32 kg (20,5 lbs.)
• Weight excluding hanging bracket: 7,65 kg (16,9 lbs.)