De Martin VDO Atomic Dot is een hybride verlichtings- en videoarmatuur die een compacte stroboscoop, kleine blinder, videopixel en een kleine spotlight combineert. De Atomic Dot is zowel verkrijgbaar in een WRM- als een CLD-kleurtemperatuurvariant. De Martin VDO Atomic Dot is ideaal voor lichtontwerpers die behoefte hebben aan een groot creatief potentieel, dankzij de combinatie van al deze aspecten in één armatuur. Daarnaast is de Atomic Dot vrijwel overal inzetbaar dankzij het compacte design en kunnen er ook grotere hoeveelheden tegelijk worden ingezet door middel van battens, arrays of creatieve vormen.
Power:
- AC power: 100-240 V AC nominal, 50/60 Hz
- Power supply unit: Auto-ranging electronic switch mode
- Typical half-cycle RMS inrush current at 230 V, 50 Hz: 1,1 A
- Typical earth-leakage current: 0,25 mA
- Power Factor: 0,99 @ 100 V , 0,98 @ 120 V , 0,95 @ 208 V , 0,96 @ 230 V , 0,94 @ 240 V
- Max current draw: 0,6 A @ 100 V / 120 V , 0,3 A @ 208 V / 230 V / 240 V
- Typical current draw: 0,5 A @ 100 V , 0,4 A @ 120 V , 0,2 A @ 208 V , 0,2 A @ 230 V , 0,2 A @ 240 V
- Maximum: 55 W
- Typical: 50 W
- Idle: 4 W
Optical and photometric:
- Lens Diameter: 95 mm
- Front Accessory Holder: PAR30 size
- Beam/Strobe LED
- LED Type: Warm White (WRM) ; Cold White (CLD)
- total lumen output: 2.850 lumens (boost/strobe mode) (WRM) ; 3.350 lumens (boost/strobe mode) (CLD)
- total lumen output: 1.400 lumens (continuous mode) (WRM) ; 1.600 lumens (continuous mode) (CLD)
- Beam Angle: 11 Degrees (half peak)
- Field Angle: 22 Degrees (one-tenth peak)
- Binning: Tight color and flux binning
- Color Temperature: 2.700 K (WRM) ; 5.700 (CLD)
- CRI (Color Rendering Index): >84 (WRM) ; >80 (CLD)
- Resolution: 16-bit
- Minimum LED lifetime: 50.000 hours (to >70% luminous output)
- Aura Backlight LEDs
- LED Type: RGB
- LED Quantity: 16
- Binning: Tight color and flux binning
- Color Temperature: Variable (2.000-11.000 K)
- Resolution: 16-bit per color per pixel
- Minimum LED lifetime: 50.000 hours (to >70% luminous output)
P3 video processing:
- Color Resolution: 16 bit per color (48 bit per pixel) (Aura)
- Color Temperature Control: 2.000-11.000 K (Aura)
- Synchronization: System-wide
- Frame Rate: Up to 75 frames/sec
- Brightness Control: 0-100% (maintaining full color depth)
- Color Gamut Control: full spectrum control (Aura)
- Gamma Correction and Control: fully controllable (Aura)
Effects:
- Beam Dimmer/Shutter: 0 – 100% continuous dimming, variable flash rate and duration, and atomic effects
- Beam Dimming options: Choice of four dimming curves
- Beam P3 Mix: Videomapping of fixture with variable crossfade between DMX control and video control
- Aura Dimmer/Shutter: 0 – 100% continuous dimming, regular and random strobe effects
- Aura Dimming options: Choice of four dimming curves
- Aura Color mixing: RGB, independently variable 0 - 100%
- Aura Color temperature control: Variable 2.000 – 11.000 K
- Aura Virtual Color wheel: 36 color presets, continuous rotation & random color
- Aura PixelMapping: individual RGB control of each Aura pixel
- Aura P3 Mix: Videomapping of fixture with variable crossfade between DMX control and video control
- Built-in FX: Various pre-programmed FX on Beam, Aura and combination of both
Heat management:
- Cooling: Convection
- Maximum ambient temperature (Ta max.): 40° C
- Minimum ambient temperature (Ta min.): 0° C
- Typical heat dissipation (calculated, +/- 10%): 171 BTU/hr
Control and programming:
- DMX channels: 1, 3, 4, 19, 64
- DMX compliance: USITT DMX512-A
- RDM compliance: ANSI/ESTA E1.20
- DMX/RDM Transceiver: RS-485
- Control Protocols: DMX, RDM, Art-Net, RDM over Art-Net, sACN and P3
- Protocol detection: Automatic
- Setting and addressing: RDM, RDM over Art-Net or P3
- DMX Modes: 1-channel, 3-channel, 4-channel, Basic, Extended
- Fixture Identification: User-settable ID number
- Art-Net Compliance: Art-Net 1, 2, 3 and 4; including RDM over Art-Net
- sACN Compliance: ANSI E1.31 – 2016
- Martin P3 Compliance: P3 System Controller Software 5.1.0 or newer
- Ethernet Transceiver: 10/100Mbit
- Firmware update: via DMX using Martin Companion or via Ethernet using P3 System Controller
- Device status: Multi-color status LED
- Device test and reset: Pushbutton to call up local test patterns and reset device
Connectors:
- AC Power, DMX and Network input: cable tail with PDE hybrid connector (IP65)
- AC Power, DMX and Network thru: chassis-mount PDE hybrid connector (IP65)
Installation:
- Mounting options: hanging from bracket, hanging from clamp attached directly to fixture or hanging from other fixture using interlock mechanism
- Location: indoor or temporary outdoor use
- Clamp attachment to hanging bracket: M12
- Clamp attachment directly to fixture: M8
- Maximum vertical column height: 16 fixtures
- Orientation: Any
- Minimum distance to combustible materials: 0,1 m
- Minimum distance to illuminated surfaces: 0,2 m
Housing:
- Housing: Aluminum
- Color: Black
- Protection rating: IP65
Physical:
- Width excluding hanging bracket: 130 mm (5,1 in.)
- Width including hanging bracket: 175 mm (6,9 in.)
- Height excluding hanging bracket: 134 mm (5,3 in.)
- Height including hanging bracket: 242 mm (9,5 in.)
- Horizontal fixture spacing: 150 mm (5,9 in.) (center-to-center using interlock couplers)
- Vertical fixture spacing: 150 mm (5,9 in.) (center-to-center using interlock couplers)
- Depth: 146 mm (5,7 in.)
- Weight including hanging bracket: 2,2 kg (4,85 lbs.)
- Weight excluding hanging bracket: 2,0 kg (4,41 lbs.)
Environmental:
- RoHS: Compliant
- REACH: Compliant
- WEEE: Compliant
- Proposition 65: Compliant
- Efficacy (max output): 63,3 lm/W (WRM) ; 74,4 lm/W (CLD)
- LWR: 1.295 lm/kg (588 lm/lb) (WRM) ; 1.523 lm/kg (691 lm/lb) (CLD)
De verhuurprijs van de Martin VDO Atomic Dot, zowel WRM als CLD, is €10,- per dag. Verkrijgbaar in sets van 12.
Bekijk onze prijslijst voor een compleet overzicht van ons aanbod en actuele prijzen of neem contact op met onze specialisten via +31 26 325 53 92.